Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
Differential Axle Housing: Service and Repair
Dana
REMOVAL
1. Disconnect the battery ground cable(s).
2. Raise and support the vehicle.
3. Loosen the adjusting nut at the parking brake cable equalizer, until the right side (upper) and left side (lower) cable anchors are free from the
equalizer retaining slots. Disconnect the cables at the equalizer.
NOTE: Prior to disconnecting the rear parking brake cables, note left and right side cable routing.
NOTE: To maintain proper adjustment, measure and record the distance from the top of the parking brake cable equalizer adjusting nut to the end
of the stud.
4. Slide the boxed end of a 13mm wrench over the rear parking brake cable and onto the cable conduit retainer. Depress the retainer locking tabs and
pull the cable conduit toward the rear of the vehicle and out from the parking brake cable support bracket.
5. Separate the left side rear parking brake cable from the support spring at the frame rail.
-
Tie-wrap the cable to the axle.
