Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
REMOVAL
1. Raise and support the vehicle.
2. Mark the driveshaft flange and rear axle companion flange for correct alignment during installation.
3. Remove the four driveshaft bolts, and disconnect the driveshaft.
4. Disconnect the parking brake cables.
1. Loosen the adjusting nut at the parking brake cable equalizer, until the right side (upper) and left side (lower) cable anchors are free from the
equalizer retaining slots.
Disconnect the cables at the equalizer.
2. Slide the boxed end of a 13 mm wrench over the rear parking brake cable and onto the cable conduit retainer. Press the retainer locking tabs,
and pull the cable conduit toward the rear of the vehicle and out from the parking brake cable support bracket. Repeat for the opposite cable.
3. Separate the left side parking brake rear cable and conduit from the support spring at the frame rail. Tie-wrap the cable to the rear axle. Wire
the driveshaft out of the way.
