Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
4. Using the Dial Indicator/Magnetic Base or Dial Indicator with Bracketry with the Clutch Housing Alignment Adapter for the indicator tip, check
the backlash of the ring gear and pinion.
-
Backlash tolerance is 0.13-0.20 mm (0.005-0.008 inch) and cannot vary more than 0.05 mm (0.002 inch) between points checked. Backlash
variation of more than 0.05 mm (0.002 inch) indicates incorrect runout.
-
High backlash is corrected by moving the ring gear toward the pinion.
-
Low backlash is corrected by moving the ring gear away from the pinion.
-
These corrections are made by changing the differential bearing selective shim thickness.
NOTE: Check the ring gear and pinion backlash at three equally spaced points.
5. Remove the axle shafts.
6. Index mark the driveshaft to the rear axle companion flange.