Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
20. Using the Pinion and Carrier Bearing Puller, remove the inner pinion bearing and the selective shim from the drive pinion.
21. Using the Pinion and Carrier Bearing Puller, remove the inner pinion bearing.
NOTE: The oil slinger is part of the drive pinion bearing adjustment shims and must be kept intact for assembly.
22. Perform the following after disassembling the axle:
-
Thoroughly clean all parts.
-
Inspect all parts for damage or wear.
-
Clean the inside of the differential case before assembling.
-
When a scored or chipped ring gear and pinion is replaced, the rear axle housing should be cleaned thoroughly.
INSTALLATION
NOTE: Before assembling the rear axle assembly, refer to Differential Case and Pinion Set Up.
1. Place the inner and outer bearing cup and shims into the rear axle differential carrier bore.
2. Place the appropriate Pinion Bearing Cup Replacer on the inner pinion bearing cup and the outer pinion bearing cup.
