Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
for all Dana rear axles.
4. Tap each bolt head alternately with a rawhide or plastic hammer to loosen the ring gear. Remove the bolts and the ring gear.
5. If required, remove the anti-lock speed sensor ring with a soft-faced hammer. Discard the anti-lock speed sensor ring.
6. Place the differential case in a vise. For full-floating rear axles, use a small drift to drive out the differential pinion shaft lock pin that secures the
differential pinion shaft. For semi-float rear axles, remove the differential pinion shaft lock bolt.
7. Remove the differential pinion shaft.
-
On full-floating rear axles; use a drift.
-
On semi-floating axles, remove by hand.
