Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
4. Install an inch lbs. torque wrench on the pinion nut and record the torque required to maintain rotation of the pinion through several revolutions.
5. Use Companion Flange Holding Tool to hold the rear axle companion flange while removing the pinion nut.
CAUTION: After removal of the pinion nut, discard it. A new nut must be used for installation.
6. Mark the driveshaft rear axle companion flange in relation to the drive pinion stem to ensure proper alignment during installation.
7. Use 2-Jaw Puller for Differential Case Bearings to remove the rear axle companion flange.
INSTALLATION
1. Lubricate the rear axle companion flange splines.
-
Use Motorcraft Synthetic Rear Axle Lubricant F1TZ-19580-B or equivalent meeting Ford specification WSL-M2C192-A.
