Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
roller bearing torque preload readings until the original recorded preload readings are obtained by rotating the pinion with a Nm (inch lbs.)
torque wrench.
-
If the original recorded preload is lower than specifications, tighten to the appropriate specification for used bearings. If the preload is higher
than specification, tighten the nut to the original reading as recorded.
CAUTION: Under no circumstances is the pinion nut to be backed off to reduce preloads. If reduced preload is required, a new collapsible
spacer and pinion nut must be installed.
6. Position the rear driveshafts, and align the marks on the rear axle companion flange.
7. Install the four rear driveshaft-to-rear axle companion flange bolts.
8. Install the brake drums.