Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
6. Remove the driveshaft flange yoke.
1. Position the driveshaft flange yoke in the U-Joint Tool.
2. Press out a bearing cup.
3. Remove the driveshaft flange yoke.
4. Press on the spider to remove the remaining bearing cup.
5. Remove the driveshaft flange yoke.
7. Remove the spider.
1. Reposition the driveshaft in the U-Joint Tool.
2. Press out the bearing cup.
3. Rotate the driveshaft.
4. Press on the spider to remove the remaining bearing cup.
5. Remove the spider.
8. Clean the yoke area at the end of the driveshaft.
ASSEMBLY
1. Install the spider.
1. Start a new bearing cup into the driveshaft yoke.
2. Position the new spider in the driveshaft yoke.
3. Position the driveshaft in the U-Joint Tool.
4. Press the bearing cup below the yoke surface.
-
Repeat for the other bearing cup.
