Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
NOTE: If only the seal needs to be replaced, it can be pried out of the tube bore. Use care to avoid damaging the seal bore.
NOTE: The axle shaft oil seal can be removed with the rear wheel bearing as a unit.
3. Remove the rear wheel bearing.
1. Install the Front Hub Remover/Replacer, the Hub Remover Adapters and the Rear Axle Bearing Remover.
2. Pull the rear rear wheel bearing from the axle tube.
WARNING: WEAR SAFETY GLASSES WHEN REMOVING THE REAR WHEEL BEARING.
4. Clean and inspect the rear wheel bearing bore.
-
Wipe the bore with emery cloth to ensure a smooth surface.
-
Clean out the bore with a standard metal-cleaning solvent. Wipe this area clean, making sure it is free of dirt or any other contaminants.
NOTE: The rear wheel bearing bore must be free from nicks and burrs. If the bore has burrs or spalled areas and a new rear wheel bearing is
installed, early failure can result.
INSTALLATION
1. Coat the rear wheel bearing with differential lubricant for easier assembly and to prevent possible scoring of the tube bore.
2. Using the Front Hub Remover/Replacer, Hub Remover Adapters, Step Plate and the Rear Axle Bearing Replacer, install the rear rear wheel
bearing.
NOTE: During bearing installation, make sure the rear wheel bearing is not cocked in the bore.
NOTE: Install the rear wheel bearing, with identification numbers on the rear wheel bearing facing out.
3. Using the Front Hub Remover/Replacer, the Hub Remover Adapters, the Step Plate and the Rear Axle Seal Replacer, install a new axle shaft oil
