Econoline E550 V10-6.8L VIN S (2003)
11. NOTE: A No. 53 drill bit (1/16-inch) can be used instead to remove the manual lever shaft retaining pin.
Using the special tool, remove the manual lever shaft retaining pin.
12. CAUTION: Be careful not to damage the manual control lever bore.
NOTE: The manual control lever and manual control lever shaft are one piece. Use a crescent wrench on the manual control lever or outer flats of
manual control lever shaft assembly when removing the inner manual valve detent lever nut.
Remove the manual valve control lever shaft assembly.
1
Remove the inner manual valve nut.
2
Remove the inner manual valve detent lever.
3
Remove the parking pawl actuating rod.
4
Remove the manual valve control lever shaft assembly.
13. Using the special tool, remove the manual control lever seal.
Installation
All vehicles