Econoline E550 V10-6.8L VIN S (2003)
components to disconnect the yoke from the flange. Pry only in the area shown with a suitable tool to disconnect the yoke from the flange.
Using a suitable tool as shown, disconnect the driveshaft centering socket yoke from the rear axle pinion flange.
^
Position the driveshaft out of the way.
5. Install a Nm (inch-pound) torque wrench on the pinion nut, and record the torque required to maintain rotation of the pinion through several
revolutions.
6. Remove the pinion flange and pinion nut.
7. Remove the rear axle drive pinion shaft oil slinger.
8. Remove the rear axle drive pinion seal.
9. Using a soft-faced hammer and the special tool, drive the pinion out of the outer pinion bearing and remove the drive pinion through the rear of the
housing.
10. Remove and discard the collapsible spacer.