Edge AWD V6-3.5L (2009)
5. Clean the inside of the glass surface with glass cleaner.
6. NOTE: Be sure to use the same brand and cure-rate products for the urethane adhesive and glass primer. Do not mix different brands of urethane
adhesive and glass primer. For additional information, refer to the Material chart in this procedure.
If installing a new glass panel, apply glass primer according to manufacturer's instructions. Allow at least 6 minutes to dry.
7. Cut the urethane adhesive applicator tip to the specification.
8. NOTE: The glass panel must be positioned within 10 minutes of applying the urethane adhesive.
NOTE: Use either a high-ratio, electric or battery-operated caulk gun that will apply the urethane adhesive with less effort and a continuous bead.
Apply urethane adhesive on top of the existing trimmed urethane adhesive bead, making sure there are no gaps in the bead.
9. WARNING: Do not drive vehicle until the urethane adhesive seal has cured. Follow urethane adhesive manufacturer's curing directions.
Inadequate or incorrect curing of the urethane adhesive seal will adversely affect glass retention. Failure to follow these instructions may
result in serious injury to vehicle occupant(s).
NOTICE: Before positioning the glass panel, open vehicle windows to prevent the air pressure of closing doors from affecting the
urethane adhesive bond.
Apply the fixed glass panel assembly to the roof module. Work the glass panel down using only vertical pressure.
10. Install the rear fixed glass interior trim ring. For additional information, refer to Roof Opening Panel Trim - Fixed Glass, Interior See: Sunroof /
Moonroof Interior Trim Panel/Service and Repair/Roof Opening Panel Trim - Fixed Glass, Interior.
11. Install the headliner.
12. Install the roof opening panel sliding glass. For additional information, refer to Roof Opening Panel Glass - Front Sliding See: Roof Opening
Panel Glass - Front Sliding.
