Edge AWD V6-3.5L (2009)
Brake Caliper
Brake Caliper
Removal
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result
in serious personal injury.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or
plastic surface, immediately wash the surface with water.
1. Remove the wheel and tire.
2. Remove the brake caliper flow bolt and position the brake hose aside.
-
Discard the 2 copper washers.
3. Remove the 2 brake caliper guide bolts and the brake caliper.
-
If a leaking or damaged caliper piston boot is found, install a new disc brake caliper.
Installation
1. NOTICE: Make sure that the caliper guide pin boots are fully seated or damage to the caliper guide pin boots can occur.
NOTE: Make sure that the brake caliper hose is not twisted during caliper installation.