Edge AWD V6-3.5L (2009)
Position the brake caliper onto the anchor plate and brake pads.
2. Install the 2 brake caliper guide pin bolts.
-
To install, tighten to 26 Nm (19 lb-ft).
3. Using 2 new copper washers, position the brake hose and install the brake caliper flow bolt.
-
Tighten to 25 Nm (18 lb-ft).
4. Install the wheel and tire.
5. Bleed the brake caliper.
Brake Caliper Anchor Plate
Brake Caliper Anchor Plate
Removal and Installation
1. Remove the wheel and tire.
2. NOTICE: Do not pry in the caliper sight hole to retract the pistons, as this can damage the pistons and boots.
NOTICE: Do not allow the brake caliper to hang from the brake hose or damage to the hose can occur.
Remove the 2 brake caliper guide pin bolts and position the caliper aside.
-
Support the caliper using mechanic's wire.
-
To install, tighten to 26 Nm (19 lb-ft).
3. Remove the 2 brake pads, shims and slide clips.
4. Remove the 2 brake caliper anchor plate bolts and the anchor plate.
-
To install, tighten to 90 Nm (66 lb-ft).
5. NOTE: Make sure that the brake caliper hose is not twisted during caliper installation.