Edge AWD V6-3.5L (2009)
To install, reverse the removal procedure.
-
Apply brakes several times to verify correct brake operation.
Brake Caliper Support Plate
Brake Caliper Support Plate
Removal and Installation
1. Remove the brake disc shield. For additional information, refer to Brake Disc Shield See: Disc Brake System/Brake Rotor/Disc/Service and
Repair/Removal and Replacement/Rear Disc Brake/Brake Disc Shield.
2. Remove the 2 parking brake cable-to-support plate bolts, disconnect the parking brake cable from the lever and position the cable aside.
-
To install, tighten to 23 Nm (17 lb-ft).
3. Remove the 2 dust boot shield bolts and the dust shield.
-
To install, tighten to 10 Nm (89 lb-in).
4. Remove the dust boot.
5. To install, reverse the removal procedure.