Edge AWD V6-3.5L (2009)
3. Release the clamp and disconnect the return hose from the steering gear.
4. Release the clamp and disconnect the return hose from the return line.
5. Remove the 3 pressure line bracket-to-steering gear bolts.
-
To install, tighten to 9 Nm (80 lb-in).
6. Disconnect the purge valve electrical connector.
7. Disconnect the 3 PCM electrical connectors and position the wiring harness aside.
8. Remove the pressure line-to-power steering pump banjo bolt and disconnect the pressure line from the pump.
-
Discard the 2 seals.
-
To install, tighten to 48 Nm (35 lb-ft).
9. To install, reverse the removal procedure.
10. Fill the power steering system.