ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3097 > < Initial Inspection and Diagnostic Overview|Page 3095
Page 84
background image

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to W30.

No

GO to W22.

-------------------------------------------------
W22 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE ABS MODULE DISCONNECTED

-

Disconnect: ABS Module C135.

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to W31.

No

If the vehicle is equipped with a 4X4 control module, GO to W23.

If the vehicle is not equipped with a 4X4 control module, GO to W24.

-------------------------------------------------
W23 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE 4X4 CONTROL MODULE
DISCONNECTED

-

Disconnect: 4X4 Control Module C281a.

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to W32.

No

GO to W24.

-------------------------------------------------

Initial Inspection and Diagnostic Overview|Page 3097 > < Initial Inspection and Diagnostic Overview|Page 3095