Edge FWD V6-3.5L (2007)
5. NOTE: If the window regulator cable was cut previously, support the regulator before the glass clamp bolt is loosened.
Loosen the glass clamp bolt.
-
To install, tighten to 9 Nm (80 lb-in).
6. Lower the window regulator downward until it reaches the stops at the bottom of the regulator tracks.
7. Disconnect the electrical connector at the B-pillar.
8. Remove the 2 bolts from the electrical harness grommet to the door.
9. Using the speaker hole for access, release the clip on the harness from the inside to disconnect the harness from the door.
10. Unclip the weatherstrip and feed through the wiring harness between the weatherstrip and door.
11. Remove the 3 door latch screws.
