Edge FWD V6-3.5L (2007)
1. NOTE: Avoid scratching the painted surfaces. For minor scratches or exposed metal, see the manufacturer's recommendations.
Using an appropriate tool, trim the urethane adhesive leaving a 1-2 mm (0.04-0.08 in) base of original equipment urethane along the roof opening
module surface.
2. Clean the inside of the glass surface with glass cleaner.
3. CAUTION: Be sure to use the same brand of cure-rate products for the adhesive and primer. Do not mix different brands of urethane
and primer. Refer to the Materials Chart in this procedure.
Cut the urethane adhesive applicator tip to the specification.
4. NOTE: Use either a high-ratio, electric or battery-operated caulk gun that will apply the urethane with less effort and a continuous bead.
Apply urethane adhesive on top of the existing trimmed urethane adhesive bead. Make sure that all gaps in the urethane adhesive are smoothed
into one continuous bead.
5. CAUTION: When installing urethane-installed glass parts, the vehicle must not be driven until the urethane has cured. Adequate cure
time is specified on the drive away chart for each urethane product as the temperatures and humidity vary. Inadequate or incorrect
curing can adversely affect the retention of the glass panel.
Apply the fixed glass panel assembly to the roof module. Work the glass panel down using only vertical pressure.
6. Install the rear fixed glass interior trim ring.
7. Install the headliner.
8. Install the roof opening panel sliding glass.
