Edge FWD V6-3.5L (2007)
4.
Tape painted roof area next to panels to prevent damage to paint. (Figure 3)
5.
Remove and discard both roof opening panel trims.
CAUTION
MAKE SURE THE CUTTING BLADES ARE CHANGED WHERE THE CUTTING DEPTH CHANGES TO AVOID DAMAGE TO THE
BODY OR GLASS.
NOTE
LUBRICATE THE URETHANE ADHESIVE WITH WATER TO AID THE SPECIAL TOOL WHEN CUTTING THE URETHANE ADHESIVE.
a.
Cut the urethane adhesive with a pneumatic knife and remove. (Figure 4)
6.
Carefully mark the location of both idler tracks in 3 places before removing any fasteners. The new idler tracks must be installed in exactly the
same position. Left hand shown, right hand similar.
7.
Remove the six (6) rear idler track-to-housing screws. (Figure 5) There is a special Replacement Screw available if a screw hole becomes stripped