Edge FWD V6-3.5L (2007)
-
TPMS
-
Oil pressure
-
Brake fluid level
-
Washer fluid level
-
Fuel level
-
Distance to empty (DTE)
System Warning Messages
The system warning messages alert the operator to possible problems or malfunctions in the vehicle operating systems. The message center displays
the last selected feature if there are no additional warning messages. Once a warning message has been displayed, the message must be acknowledged
to allow full functionality of the message center. Press the RESET to acknowledge and clear the warning message. The warning messages are divided
into 3 basic categories:
-
Cannot be cleared until the condition is corrected.
-
Reappears 10 minutes from pressing the RESET button.
-
Reappears if the condition clears then reoccurs within the same ignition cycle ON-OFF cycle.
The warning messages that cannot be reset are:
-
DRIVER DOOR AJAR
-
PASSENGER DOOR AJAR
-
REAR LEFT DOOR AJAR
-
REAR RIGHT DOOR AJAR
-
PARK BRAKE ENGAGED
-
PLEASE CLOSE DOOR
-
PRESS RESET TO CLEAR
The warning messages that reoccur after 10 minutes are:
-
LOW FUEL LEVEL
-
CHECK BRAKE SYSTEM
-
LOW BRAKE FLUID LEVEL
The warning messages that display whenever the ignition switch is turned from the OFF position to the ON position are:
-
WASHER FLUID LEVEL LOW
-
LIFTGATE AJAR
-
LOW TIRE PRESSURE
-
CHECK RPA (if equipped)
-
CHECK COMPASS MODE (if equipped)
-
COMPASS NO RESPONSE (if equipped)
-
COMPASS DATA ERROR
-
TIRE PRESSURE MONITOR FAULT
-
TIRE PRESSURE SENSOR FAULT
-
POWER LIFTGATE OFF
-
PARK ASSIST OFF
Service Procedure Displays
The message center displays warning messages that indicate a system state during repair procedures related to the tire pressure monitoring system
(TPMS). The displayed warning messages are as follows:
-
TRAIN MODE: TRAIN xx TIRE
-
TIRE TRAINING MODE COMPETE
-
TIRE NOT TRAINED - REPAIR
The message center displays warning messages that indicate a system state during repair procedures related to the compass display. The displayed
warning messages are as follows:
-
RESET FOR ZONE
-
SETUP ZONE XX
-
RESET FOR CAL
-
CIRCLE SLOWLY TO CALIBRATE
-
CALIBRATION COMPLETE
The message center displays the IKT KEY COULD NOT PROGRAM warning message to indicate a problem programming the integrated key
transmitter (IKT).
