Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
8. Raise the second row seat backrest.
9. Install the safety belt anchor.
1
Position the safety belt anchor.
2
Using the special tool, install the bolt.
NOTE: Make sure the safety belt webbing is not twisted prior to installation.
10. Install the C-pillar weatherstripping.
11. Install the rear door scuff plate.
1
Position the rear door scuff plate.
2
Install the two pin-type retainers (one shown).
3
Close the cover.
12. Check the active restraint system for correct operation.
1
Make sure that after the rear safety belt retractor is installed, the retractor is not in the Automatic Locking Retractor (ALR) mode.
2
Carry out the Emergency Locking Retractor (ELR) Mode Functional Test to make sure that the new retractor operates correctly. See: Testing
and Inspection/Component Tests and General Diagnostics/Functional Test - Emergency Locking Retractor (ELR) Mode