Escape 2WD L4-2.5L (2009)
2. Install the manual shaft in the transaxle case through the TR sensor.
3. Using a suitable tool such as center punch or a 5.5 mm (0.216 in) socket and a 101.6 mm (4 in) extension 1/4 inch drive, install a new TR sensor
locking pin.
4. Install the TR sensor detent spring and bolt.
-
Tighten to 12 Nm (106 lb-in).
5. Connect the TR sensor electrical connector.
6. Install the main control cover grommet.
7. Clean the main control cover sealing surface.