Escape 2WD L4-2.5L Hybrid (2010)
Auxiliary Step / Running Board: Service and Repair
Running Board
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Release the running board trim bezel push clips and remove the running board trim bezel.
3. Remove the 4 running board bolts and remove the running board.
-
To install, tighten to 25 Nm (18 lb-ft).
4. Remove the body-to-running board bracket screw.
-
To install, tighten to 10 Nm (89 lb-in).
5. To install, reverse the removal procedure.