Escape 2WD L4-2.5L Hybrid (2010)
Rear Door Window Glass Weatherstrip: Service and Repair
Door Glass Top Run - Rear
Door Glass Top Run - Rear
Removal and Installation
1. Remove the rear door window regulator. For additional information, refer to Window Regulator - Rear Door See: Doors, Hood and
Trunk/Doors/Rear Door/Rear Door Window Regulator/Service and Repair/Window Regulator - Rear Door.
2. Position the rear door window glass to the full DOWN position.
3. Remove the 2 screws and the rear door exterior sail panel.
4. Remove the interior door glass weatherstrip.
5. Remove the exterior door glass weatherstrip.
6. Remove the rear door glass top run bolt.
-
To install, tighten to 6 Nm (53 lb-in).
7. Position the rear door window glass down and forward.
8. Remove the rear door glass top run.
9. To install, reverse the removal procedure.
