Escape 4WD L4-2.5L Hybrid (2009)
Upload the ACM configuration to the scan tool.
2. Remove the middle instrument panel center finish panel.
3. Remove the 4 ACM screws.
-
To install, tighten to 2 Nm (18 lb-in) (navigation).
-
To install, tighten to 1 Nm (9 lb-in) (all except navigation).
Navigation
4. Disconnect the antenna and electrical connectors.
All except navigation
5. If equipped, remove the 4 screws and the ACM side support brackets.
6. NOTE: Only carry out this step if installing a new ACM.
Remove the 2 ACM brackets.
All vehicles
7. Remove the ACM.
8. To install, reverse the removal procedure.
-
Download the configuration information to the ACM.
Accessory Protocol Interface Module (APIM)
Accessory Protocol Interface Module (APIM)
Removal and Installation
1. NOTE: It is necessary to record the current Accessory Protocol Interface Module (APIM) software and hardware level when a new APIM is being
installed to make sure that the new component is the same version as the component being replaced.
Retrieve and record the current APIM software and hardware level. For additional information, refer to Accessory Protocol Interface Module
(APIM) Software Level Check See: Procedures/Accessory Protocol Interface Module (APIM) Software Level Check.
