Escape 4WD L4-2.5L Hybrid (2009)
2. Remove the floor console.
3. Disconnect the APIM electrical connector and the Universal Serial Bus (USB) cable electrical connector.
4. Remove the 3 screws and the APIM.
-
Slide the APIM upward to release the locator clips.
5. To install, reverse the removal procedure.
-
If a new APIM is being installed, program the APIM to the correct software level.
Universal Serial Bus (USB) Cable and Port
Universal Serial Bus (USB) Cable and Port
Floor Console Trim Panels
Universal Serial Bus (USB) Port and Cable
Removal and Installation