Escape 4WD L4-2.5L Hybrid (2009)
Remove the 2 bolts, the nut and position aside the hood latch.
-
To install, tighten to 9 Nm (80 lb-in).
6. Remove the center support lower bolt.
-
To install, tighten to 10 Nm (89 lb-in).
7. Remove the bolt and the center support.
-
To install, tighten to 10 Nm (89 lb-in).
8. Remove the 2 bolts and position the auxiliary coolant pump aside.
-
To install, tighten to 7 Nm (62 lb-in).
9. Disconnect the cooling fan resistor electrical connector.
10. Disconnect the 2 cooling fan electrical connectors.
11. Remove the 6 cooling fan bolts.
-
To install, tighten to 8 Nm (71 lb-in).
12. NOTE: Remove the LH cooling fan first and slide the RH cooling fan to the left side to remove.
Remove the LH and the RH cooling fans.
13. To install, reverse the removal procedure.