Escape 4WD L4-2.5L Hybrid (2009)
Battery, Hybrid Drive: Service and Repair
High Voltage Traction Battery - 12 Volt Battery
12 Volt Battery
Removal and Installation
WARNING: Batteries contain sulfuric acid and produce explosive gases. Work in a well-ventilated area. Do not allow the battery to come in
contact with flames, sparks or burning substances. Avoid contact with skin, eyes or clothing. Shield eyes when working near the battery to
protect against possible splashing of acid solution. In case of acid contact with skin or eyes, flush immediately with water for a minimum of 15
minutes, then get prompt medical attention. If acid is swallowed, call a physician immediately. Failure to follow these instructions may result in
serious personal injury.
WARNING: Always lift a plastic-cased battery with a battery carrier or with hands on opposite corners. Excessive pressure on the battery end
walls may cause acid to flow through the vent caps, resulting in personal injury and/or damage to the vehicle or battery.
1. Disconnect the 12-volt battery.
2. Remove the Air Cleaner (ACL) assembly.
3. Remove the battery wedge clamp and bolt.
-
To install, tighten to 9 Nm (80 lb-in).
4. Remove the battery.
5. Remove the 4 bolts and the battery tray.
-
To install, tighten to 9 Nm (80 lb-in).
6. To install, reverse the removal procedure.