Escort L4-110 1.8L DOHC (1994)
Compressor Clutch Relay: Testing and Inspection
A/C Relay Conditional Chart
A/C Relay
1. Disconnect the A/C relay connector.
2. Use a Rotunda 73 Digital Multimeter 105-00051 or equivalent, on the diode/continuity check setting. Check the diode in the A/C relay as follows:
a. Check the continuity of the A/C relay diode with the positive multimeter lead on the "BL/BK" wire terminal and the negative multimeter lead
on the "BK/GN" wire terminal at the A/C relay. No continuity should exist.
b. Check the continuity of the A/C relay diode with the positive multimeter lead on the "BK/GN" wire terminal and the negative multimeter lead
on the "BL/BK" wire terminal at the A/C relay. Continuity should exist.
3. Measure the resistance between the "BK/R" and "BK" wire terminals at the A/C relay. The resistance should be less than 5 ohms.
4. Apply 12 volts to the "BL/GN" and "BL/Y" wire terminals at the A/C relay.
5. Measure the voltage on the "BK/R" wire terminal at the A/C relay according to the results in the "A/C Relay Conditional Chart".
6. If all the measurements are correct, return to Pinpoint Tests. Otherwise, replace the A/C relay.