Escort L4-122 2.0L SOHC (1997)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor
Front
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the windshield washer pump and reservoir.
3. Peel back the foam insulation from the front brake anti-lock sensor electrical connector and disconnect.
4. Remove the wheel and tire assembly.
5. Remove the upper sensor cable bracket bolt (1).
6. Remove the bracket and cable assembly (2).
7. Remove the grommet and pull the sensor cable through the opening.
8. Remove the anti-lock cable clamp bolt (1).
9. Remove the anti-lock cable clamp (2).
10. Remove the two bolts (3) and remove the front brake anti-lock sensor (4).
INSTALLATION - To install, reverse the removal procedure.
NOTE: Tighten Sensor bolts to 16-22 Nm (12-16 ft.lbs.).
To install, reverse the removal procedure.
Rear
REMOVAL