ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Starting and Charging > < Toothed Ring|Page 6661
Page 2
background image

1. Disconnect the battery ground cable.
2. Disconnect the rear brake anti-lock sensor electrical connector.
3. Remove the rear brake anti-lock sensor grommet.

4. Disconnect the rear brake anti-lock sensor wire from the upper harness clip.
5. Disconnect the rear brake anti-lock sensor wire from the lower harness clip.

6. Remove the rear brake anti-lock sensor bolt.
7. Remove the rear brake anti-lock sensor.

INSTALLATION

NOTE: Tighten sensor bolt to 19-25 Nm (14-18 ft. lbs.) 

^

To install, reverse the removal procedure.

^

Bleed the brake system. 

Starting and Charging > < Toothed Ring|Page 6661