Excursion 2WD V10-6.8L VIN Z CNG (2003)
7. CAUTION: Prevent the front of the valve body separator plate from sagging and displacing the check balls.
If the valve body separator plate is not being serviced:
1
Remove the bolt.
2
Install the bolt into any case-threaded bolt hole on the opposite end of the separator plate.
8. Remove the main control valve body assembly.
1
Remove the bolts.
2
Remove the nuts.
3
Remove the main control valve body.
9. Remove the solenoid body assembly.
1
Remove the bolts.
2
Remove the nut.
3
Remove the solenoid body assembly.