Excursion 2WD V10-6.8L VIN Z CNG (2003)
10. Remove the solenoid screen assembly by rotating and pulling.
11. CAUTION: The steel Electronic Pressure Control (EPC) check ball is spring-loaded under the valve body separator plate.
NOTE: If the valve body separator plates are not to be serviced, proceed to installation procedure.
Remove the valve body separator plate reinforcement.
1
Remove the bolts.
2
Remove the separator plate reinforcement.
12. Lower and remove the valve body separator plate and gaskets.
^
The rubber check balls and the steel EPC check ball and spring assembly will fall out and may become lost or stick to the worm trail of the
case.
^
Remove and discard separator plate gaskets.
Installation