Excursion 4WD V10-6.8L VIN S (2000)
![background image](/ford/excursion_4wd/v10-6.8l_vin_s/Page-944007.png)
7. Loosely install the bolts, then tighten the bolts in the two stages, in the sequence shown.
^
Stage 1: Tighten to 20 Nm (15 ft. lbs.).
^
Stage 2: Tighten an additional 60 degrees.
8. Connect the crankshaft position sensor electrical connector.
9. Note: The front lower hole in the power steering pump is not used.