Excursion 4WD V10-6.8L VIN S (2000)
vehicle being repaired. Safety belt assemblies must not be interchanged between vehicle models.
^
Safety belt buckles are shown, safety belt and buckle is similar.
1. Remove the rear seat back.
2. Remove the safety belt buckles.
1
Using the special tool 501-010 (T77L-2100-A), remove the bolt.
2
Remove the safety belt buckles.
INSTALLATION
1. To install, reverse the removal procedure.
^
See the removal procedure or Specifications for torque specifications.
NOTE:
^
Make sure the safety belt webbing is not twisted prior to installation.
^
Make sure to tighten bolts to specification.
2. Check the restraint system for correct operation.
Crew Cab
Torx Bit Tool Set Used For T55 "Torx Plus" Bit
SPECIAL SERVICE TOOL(S)
REMOVAL
NOTE: Rear bench seat shown, rear captains chair is similar.
1. Remove the utility tray, if necessary.