Excursion 4WD V10-6.8L VIN S (2000)
1. Install the third row safety belt retractor.
1
Position the third row safety belt retractor to the body.
2
Using the special tool 501-010 (T77L-2100-A), install the bolt.
CAUTION: Do not remove the shipping clip until the safety belt guide is secured in position. Allowing the safety belt to be retracted further into
the safety belt retractor may cause the safety belt retractor to lock and not release the safety belt.
Second row retractor only
2. Install the second row safety belt retractor.
1
Position the second row safety belt retractor to the body.
2
Using the special tool 501-010 (T77L-2100-A), install the bolt.
CAUTION: Do not remove the shipping clip until the safety belt guide is secured in position. Allowing the safety belt to be retracted further into
the safety belt retractor may cause the safety belt retractor to lock and not release the safety belt
3. Route the second and third row safety belt anchors and guides through the B-pillar trim panel.
4. Position the quarter trim panel to the body and connect the power point electrical connector.
NOTE:
^
Do not secure the quarter trim panel as the shipping clip(s) will need to be removed from the safety belt retractor(s) later.
^
Driver side is shown, passenger side is similar.