Excursion 4WD V10-6.8L VIN S (2000)
Tighten the Handle to achieve the specified rotational torque.
8. Note: The special tool must be offset to obtain an accurate reading.
Rotate the special tool several half-turns to ensure proper seating of the pinion bearings, and position the special tool.
9. Install the special tool.
1. Position the special tool.
2. Install the differential side bearing caps.
3. Install the differential side bearing cap bolts.
10. Note:
^
Drive pinion bearing adjustment shims must be flat and clean.
^
A slight drag should be felt for correct shim selection. Do not attempt to force the pinion shim between the Gauge Block and the Gauge Tube.
This will minimize selection of a pinion shim thicker than required, which results in a deep tooth contact in the final assembly of integral rear
axle assemblies.
