Expedition 2WD V8-281 4.6L SOHC (1998)
4. To decrease caster and camber, use the following steps.
(1) To decrease caster, move the front of the front suspension upper arm inboard and move the rear of the front suspension upper arm outboard.
(2) To decrease camber, move the front suspension upper arm inboard equally.
5. Set the caster and camber to specifications.
-
If a caster increase of 1.2 degrees is required, move the front of the front suspension upper arm outboard by 3 notches and move the rear of the
front suspension upper arm inboard by 3 notches, since one notch represents 0.4 degree.
NOTE: Each increment of the notches on the frame pocket represents 0.4 degree.
6. Tighten the upper suspension arm nuts.
