Expedition 2WD V8-281 4.6L VIN W EFI (1997)
-
Specification shown is the maximum ring gear backface runout allowable.
6. Mark one differential bearing cap in relation to the axle housing to ensure the differential bearing caps are installed in their original positions
during installation.
CAUTION: The differential bearing caps must not be interchanged or rotated.
NOTE: The direction and location of the triangles on the bearing caps must remain in the same position for installation.
7. Loosen the differential bearing caps.
(1) Loosen the differential bearing cap bolts.
(2) Loosen the caps.
8. Use a pry bar and a wood block to loosen the differential case.
CAUTION: Place a wood block between the pry bar and the axle housing to protect the machined surface from damage.
9. Remove the differential case.