Expedition 2WD V8-281 4.6L VIN W EFI (1997)
ASSEMBLY
1. Install the bearing cup.
(1) Start a new bearing cup into the driveshaft yoke.
(2) Position the new spider in the driveshaft yoke.
(3) Position the (A) driveshaft in (B) U-Joint Tool.
(4) Press the bearing cup below the yoke surface.
2. Remove the driveshaft from U-Joint Tool and install the snap ring.
NOTE: Use the yellow snap rings supplied in the kit to assemble the universal joint (U-joint). If difficulty is encountered with the yellow snap
rings, install the black snap rings.
3. Repeat steps 1 and 2 for the opposite side of the driveshaft yoke.
4. Repeat steps 1 through 3 to install the remaining new bearing cups, spider, driveshaft slip yoke, driveshaft flange yoke and snap rings.
5. Check the U-joints for freedom of movement.
NOTE: Do not strike the bearings.
-
If binding, strike the yoke with a brass or plastic hammer.
6. If necessary, use Premium Long-Life Grease XG-1-C or-K or equivalent meeting Ford Specification ESA-M1C75-B to lubricate the U-joints.
7. Install driveshaft.