Expedition 2WD V8-5.4L (2009)
Seat Heater Control Module: Service and Repair
Heated Seat Module - Second Row
Heated Seat Module - Second Row
NOTE: Bottom of floor console shown.
Removal and Installation
1. Remove the front floor console.
2. Disconnect the 2 heated seat module electrical connectors at the bottom of the front floor console.
3. Remove the screw and un-hook the heated seat module.
4. To install, reverse the removal procedure.
5. Carry out the auto-configuration sequence to program the heated seat module for use with a dual momentary switch.
-
Start the vehicle and push the low button on either heated seat switch.
-
Operate the heated seats, monitor the indicators and verify the system is operating correctly in high and low.
