Expedition 2WD V8-5.4L (2009)
3. Remove the kneeling release (cargo mode) handle.
-
Raise the handle to access the cable.
-
Detach the cable jacket from the kneeling release handle.
-
Release the retainers and position aside the kneeling release handle.
4. Release the lower backrest cover J-clip.
5. Position aside the backrest cover rear flap and remove the 4 pin-type retainers.
6. If equipped, disconnect the backrest heater mat electrical connector.
-
Release the cushion cover rear J-clip.
-
Disconnect the electrical connector.
-
Detach the electrical connector and heater mat wiring.
7. Raise the backrest and route the J-clip between the backrest and cushion.
8. NOTICE: Use care when separating the seat backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip may be torn
from the seat backrest foam pad.
Invert the backrest cover to the row of hog rings.
-
Separate the hook-and-loop strips.
-
If equipped, route the heater mat wiring through the backrest cover.
9. Remove the row of hog rings.
10. Continue inverting the backrest cover to the head restraint guides.
11. NOTICE: Use care when separating the head restraints and spring clips to avoid tearing or damaging the backrest cover.
Pinch the head restraint guide ends to release and remove the 2 head restraint guides.
12. Remove the backrest cover.
13. To install, reverse the removal procedure.
Seat Cushion Cover - Second Row, 20 Percent
Seat Cushion Cover - Second Row, 20 Percent
Removal and Installation
