Expedition 2WD V8-5.4L (2009)
NOTE: For parts identification and locations, refer to Seat - Exploded View, Second Row See: Service and Repair/Second Row Seats/Seat - Exploded
View, Second Row.
1. Release the 2 backrest cover lower J-clips.
2. Remove the screw and pivot bolt cover.
-
Route out the attaching strap.
3. Remove the 2 pin-type retainers and lower panel.
4. Lower the backrest, release the cushion cover rear J-clip and route between the cushion and backrest.
5. Release the hook-and-loop strip and remaining cushion cover J-clips.
6. Remove the cushion foam pad and cushion cover together.
7. NOTICE: Use care when separating the seat cushion cover from the hook-and-loop strip, or the hook-and-loop strip may be torn from
the seat cushion foam.
Release the hook-and-loop strips and invert the cushion cover to the row of hog rings.
8. Remove all hog rings and cushion cover.
9. To install, reverse the removal procedure.
Seat Cushion Cover - Second Row, 40 Percent
Seat Cushion Cover - Second Row, 40 Percent
Removal and Installation
1. With the seat in the E-Z entry position, release the rear J-clip and partially invert the cushion cover.
2. Release the trim cover J-clips from both sides of the cushion.
3. Release the outer and inner rear J-clips from the cushion.
4. If equipped, disconnect and detach the cushion heater mat electrical connector and heater mat wiring.
5. Latch the seat to the floor and raise the backrest.
6. Release the front J-clip from the cushion.
7. Release the 2 cushion trim cover retainers from the 2 child safety seat lower anchors and tethers for children anchors.
-
Pull the cushion trim cover rearward and release the 2 clips.
