Expedition 2WD V8-5.4L (2009)
7. NOTE: When installing a new DCSM, it is necessary to carry out Programmable Module Installation (PMI). See: Powertrain
Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning
If passenger seat, remove the DCSM.
-
Cut and remove the wiring harness tie strap.
-
Release the 2 locking wedges.
-
Disconnect the 3 electrical connectors.
Driver memory seat
8. Remove the DSM.
-
Disconnect the 4 electrical connectors.
-
Release the 2 tabs and slide out the DSM.
All seats
9. Remove the cushion frame, foam pad and cushion cover assembly from the seat track.
-
Remove the 4 cushion frame-to-seat track bolts.
-
To install, tighten to 25 Nm (18 lb-ft).
-
Release the 2 cushion frame rear clips and straps from the seat track and remove the cushion frame.
10. Disconnect the 3 seat track motor electrical connectors.
-
For driver seat with memory, disconnect the additional 3 motor sensor electrical connectors.
11. Remove the wire harness.
-
Remove the 3 wire harness bracket screws.
-
Remove the tie strap and release the rear wire harness bracket clip from the seat track.
-
Separate the electrical connectors and wire harness from the seat track.
-
Remove the wire harness and bracket.
-
For correct installation, note wire harness routing.
12. To install, reverse the removal procedure.