ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Cooling Module|Page 2382 > < Cooling Module|Page 2380
Page 3
background image

14. Remove the condenser inlet fitting bolt, the condenser outlet fitting nut and disconnect the 2 fittings.

-

Discard the O-ring seals.

15. Disconnect the horn assembly electrical connector.

16. Disconnect the ambient temperature sensor electrical connector.

17. Remove the 6 cooling module bolts and remove the cooling module from the vehicle.

Installation

1. Position the cooling module in the vehicle.

2. Install the 6 cooling module bolts.

-

Tighten to 25 Nm (18 lb-ft).

Cooling Module|Page 2382 > < Cooling Module|Page 2380