Expedition 2WD V8-5.4L (2009)
3. Connect the ambient temperature sensor electrical connector.
4. Connect the horn assembly electrical connector.
5. Using new O-ring seals, connect the A/C condenser outlet and inlet fittings and install the nut and bolt.
-
Tighten to 15 Nm (133 lb-in).
6. Connect the transmission fluid cooler tubes and install the 2 secondary latches.
7. Position the air deflector and install the pushpin.
8. Position the hood latch assembly and install the 2 hood latch assembly bolts.
-
Tighten to 25 Nm (18 lb-ft).