Expedition 2WD V8-5.4L (2009)
23. NOTICE: Only use hand tools when loosening the engine support insulator through bolts or damage to the engine support
insulator-to-cylinder block bracket can occur.
Loosen the RH engine support insulator through bolt.
24. NOTICE: Only use hand tools when removing the engine support insulator through bolts or damage to the engine support
insulator-to-cylinder block bracket can occur.
Remove the LH engine support insulator through bolt.
25. Using the Engine Support Bar, Support Hook and Engine Support Bracket, raise the engine.
26. NOTICE: Only use hand tools when removing the engine support insulator-to-frame bolts or damage to the engine support
insulator-to-frame nut plate can occur.
Remove the 3 engine support insulator-to-frame bolts.
-
Discard the 3 bolts.
27. Remove the 3 bolts and the LH engine support insulator-to-cylinder block bracket.
28. Remove the LH engine support insulator.
29. Inspect the engine support insulator-to-frame nut plate for thread damage. If the nut plate is damaged, bend 2 tabs back and remove the nut plate.
Replace the nut plate with service part number 56190 and bend the 2 tabs back to the original position.
Installation
RH engine support insulator
1. Clean the engine support insulator-to-cylinder block and engine support insulator-to-frame mating surfaces of any dirt or foreign material prior to
installation.
2. NOTICE: Only use hand tools when installing the engine support insulator stud bolts or damage to the engine support insulator can
occur.
Position the RH engine support insulator into the vehicle and install the 2 stud bolts.
-
Tighten to 15 Nm (133 lb-in).
