Expedition 2WD V8-5.4L (2009)
12. Install the axle shaft housing carrier bushing bolt.
-
Tighten to 115 Nm (85 lb-ft).
13. Install the upper front axle carrier mounting bushing bolt.
-
Tighten to 115 Nm (85 lb-ft).
All engine support insulators
14. NOTICE: Only use hand tools when installing the transmission mount-to-crossmember nuts or damage to the transmission mount can
occur.
Install the transmission mount-to-crossmember nuts.
-
Tighten to 103 Nm (76 lb-ft).
15. Position the Y-pipe and install the 4 nuts (2 RH and 2 LH).
-
Tighten to 40 Nm (30 lb-ft).
16. Remove the Engine Support Bar, Support Hook and Engine Support Bracket.
