ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3041 > < Initial Inspection and Diagnostic Overview|Page 3039
Page 69
background image

No

GO to V35.

-------------------------------------------------
V35 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE ACM DISCONNECTED

-

Disconnect: ACM C240b.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT all modules. CONNECT the negative battery cable. GO to V60.

No

GO to V36.

-------------------------------------------------
V36 VERIFY VEHICLE EQUIPMENT - AUDIO DSP MODULE

-

Inspect the vehicle for an audio DSP module.

-

Is the vehicle equipped with an audio DSP module?

Yes

GO to V37.

No

GO to V38.

-------------------------------------------------
V37 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE AUDIO DSP MODULE
DISCONNECTED

-

Disconnect: Audio DSP Module C2364c.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT all modules. CONNECT the negative battery cable. GO to V61.

No

GO to V38.

Initial Inspection and Diagnostic Overview|Page 3041 > < Initial Inspection and Diagnostic Overview|Page 3039